![]() The Com Port properties shows same Interrupt Request 03 and I/o range 0258-02ff as expected. ![]() Normal comm.drv is seen as expected, dated. I checked the System|DeviceDrivers|Modem properties and it agrees use is Com2, Interrupt is 3, Address is 2f8 UART is Ns16550AN. The modem, brand new from Gateway (56k pci voice modem sf-11561vr9a) worked fine at the office so I brought it home and tested it last, after two other brands had the same message. Other than a keyboard and monitor there is nothing in the Device manager list to add confusing conflicts. Verify that the interrupt for the port is properly set.” To make it simple and easy I wiped the hard drive clean, loaded Windows 95 after the Format, and only the mouse is on Com1 and the Modem is on Com2. Make sure it is properly connected and turned on. ![]() I can see it when I click on Modems|Diagnostics|MoreInfo, but the more information pops an error message saying that “The modem failed to respond. Under Windows 95b with plug and play, using the Modem wizzard I can Add my modem, when it was not automatically detected. After several different good modems were attempted to be installed on my cyrix 686, I am without a clue what to check or do next.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |